Learn More About Plumbing For Your Home
Many people think that tackling your own plumbing can be hard work. If you take the time to research the problem ahead of time, though, you will have an easier time fixing it. You can be well on the way to a successful plumbing project, if you make use of the tips you'll find below.
Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.
Make sure you clean out overflow holes in your kitchen and bathroom sinks on a regular basis. These holes are intended to act as an emergency fail-safe to prevent spillage from a full sink, but if they are clogged they can't do their job. You can clean out an overflow hole using the same techniques you would for a clogged drain.
Find out the plumbing codes in your local area before starting any project. Plumbing codes can vary wildly from area to area and you don't want to run afoul of the codes. Visit your local building department to find out information or hire a plumber for a day to help you go over your plans and provide advice.
Do not ignore a slow flushing toilet. This is usually a sign that something is wrong. It can also cause backups and overflows. The most common causes of a slow flushing toilet are sediment build up, tank malfunctions, or partial clogs. You should periodically check for these problems.
When using the garbage disposal, do not even bother running the water. While many people think that running water in conjunction with the disposal will cause it to work more efficiently, it simply isn't true. In fact, it could cause garbage to stick to your disposal, which can create more damage.
It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.
Before embarking on a plumbing project, make sure that you're aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you'll be able to stop the water flow.
Keep an eye on the hoses for your dishwasher and washing machine. These hoses can leak and bulge, which can be a problem. Check them for signs of wear and tear and replace any hoses more than 10 years old. You'll find that these hoses age well, but you have got to make sure they are doing the job they should.
Avoid pouring grease or oil down your kitchen sink drain. Grease and oil can build up in your pipes and cause a backup. Instead, wait for the grease or oil to cool and solidify and either throw it away or see if there's a place to recycle it near your home.
If you have an odor coming from one or more fixtures in your house, it is likely this has to do more info with the water in water traps. Each fixture has a water trap that is sealed off to prevent odors. If the water evaporates, the odors can surface. Therefore, try adding water to the traps.
If you have a foul odor coming from your garbage disposal, this is due to food debris buildup. You need to put ice cubes, orange peels, and lemon peels into the disposal and run for about 30 seconds. Next, run some liquid dish soap through the disposal. This should take care of the problem if there is not a substantial blocking buildup.
When getting plumbing quotes for your home, make sure you receive them in writing. Your quote should have the material and labor costs so that both parties know what to expect from the job. If you do not get it in writing, when the job starts, you have nothing to fall back on.
Keep an eye on your monthly water bill to catch plumbing problems. Has your water bill gone up recently, even though nothing's changed? This could indicate a water leak or appliance problem somewhere inside or outside of your home. Check under sinks for rusted pipes, look for water puddles under outside faucets, and consider having a plumber come out to listen to your pipes to detect running water.
To prevent hair from clogging your drains, install strainers in each tub and shower to capture the hairs before they can go down the drain. When combined with soap build-up, hair can bring your drains to a complete standstill, so it's important to prevent the hairs from reaching the pipes in the first place.
Do not put stringy or fibrous items into your garbage disposal. Substances like banana peels, gristle, or celery may not completely break down in the disposal, and may clog your pipes instead of flowing out of the waste lines as they are supposed to. When in doubt, do not try to dispose of something that may not break down completely.
If the hot water heater in your house is over ten years old, you should look at replacing it. Hot water heaters are very susceptible to corrosion on the bottom. This can lead to leaking and flooding whatever room it is in. Then not only will you have to replace it, but you'll have to fix any damage caused by the leak.
As was discussed at the beginning of the article, while plumbing can be an extremely difficult chore for anyone to complete, it becomes significantly easier if you have the right advice and information. Use the advice from this article, and you'll be on your way to doing your own plumbing.
Meet Bernard the Roughneck, Canada's Joe the Plumber
Canada may have found its very own Joe the Plumber in Bernard Hancock, aka Bernard the Roughneck, a 32-year-old oil-rig worker who made waves when he showed up to the House of Commons dressed in greasy coveralls and a red hard hat.
Like the American Samuel Joseph Wurzelbacher, who rose to fame as a right-wing everyman during the 2008 US presidential election, Hancock has become the public face of the Alberta oil industry and its employees.
His face and his trademark mop of curly hair are plastered on T-shirts and mugs.
Last week, he appeared on Parliament Hill in his oil-rig getup to support a petition asking the federal government to do more to help Canada's struggling oil and gas industry.
"Families are being destroyed," he said.
The petition, which had 35,000 signatures, was tabled by Alberta Conservative MP Shannon Stubbs and organised by the Canadian Association of Oilwell Drilling Contractors (CAODC), a pro-oil advocacy group.
Canada’s climate change dilemma
Like many, Mr Hancock was lured out to Alberta with the promise of relatively high wages for relatively low-skilled work. Canada exports CA$220bn (USD$168bn; £129bn) in natural resources a year, mostly to the United States, and the sector accounts for 17% of its GDP, according to 2015 data provided by Natural Resources Canada.
In Alberta, the third-largest oil producer in the world, the oil and gas industry employed approximately 155,000 people in 2015, about 11% fewer than in 2014, according to the Alberta government.
The Canadian Association of Petroleum Producers says that since 2015, the industry lost 40,000 direct jobs - 100,000 when one includes indirect jobs.
Industry advocates blame the downturn on the low price of oil, the cancellation of the Keystone XL pipeline project in 2015, and the federal Liberal government's proposal to introduce a carbon tax.
https://docs.google.com/presentation/d/1aPtc6NECGxbLP-wpZEG0k3o0zCyyXmaz3nqzCM8y_N8/edit?usp=sharing